pylabrobot.formulatrix.mantis.driver.simulator.MantisSimulationArm.move_to_location#

async MantisSimulationArm.move_to_location(*, location: Coordinate, minimum_traverse_height_start: float | None = None, xy_speed: float | None = None, xy_acceleration: float | None = None, z_speed: float | None = None, z_acceleration: float | None = None) → None#

Move the nozzle to a deck-frame location: across as move_to_xy_position, then down as move_to_z_position.

Every target is checked at the location before anything moves; Z’s target is then taken where the head stands after the move across. Nothing here avoids the chip racks.

Parameters:
  • location (Coordinate) – the nozzle’s x, y and height above the deck, mm.

  • minimum_traverse_height_start (float | None) – the nozzle’s height above the deck to rise to first, mm, over both ends; default_minimum_traverse_height when None.

  • xy_speed (float | None) – the nozzle’s, mm/s; None takes default_xy_speed.

  • xy_acceleration (float | None) – the nozzle’s, mm/s²; None takes default_xy_acceleration.

  • z_speed (float | None) – mm/s; None takes default_z_speed.

  • z_acceleration (float | None) – mm/s²; None takes default_z_acceleration.

Raises:
  • MantisConfigurationError – without the unit’s arm or stage block; nothing is sent.

  • MantisMotionError – if the arm is not brought up, a motor faults, or Z does not read at the traverse height after rising to it.

  • MantisKinematicsError – if the location is out of the arm’s reach.

  • ValueError – if a target is outside its motor’s limits, or a speed or acceleration out of range.

Return type:

None