pylabrobot.formulatrix.mantis.driver.simulator.MantisSimulationPlateClamp#

class pylabrobot.formulatrix.mantis.driver.simulator.MantisSimulationPlateClamp(*, driver: MantisSimulationDriver, levels: Dict[int, Tuple[float, int]] | None = None, auxiliary_output: int | None = None, pump: Pump | None = None)#

Bases: PlateClamp

A plate clamp with no device behind it: each command sets the state it ends in, at once; a valve on a pressure-board output switches at once.

Attributes

auxiliary_output

The pressure-board output switching the clamp's valve; None for a clamp on board 12.

default_lock_level

Methods

__init__(*, driver[, levels, ...])

lock(*[, level])

On board 12, release the clamp, lock it at level and wait until it reads clamping done; if it does not, it is released again before raising.

request_locked(*[, attempts])

Whether the clamp holds: on board 12 whether it reports clamping done; on a pressure-board output whether its valve reads switched on, which is not plate contact.

request_state(*[, attempts])

The simulated state; refused for a valve on a pressure-board output, as for PlateClamp.

unlock()

Release the clamp: on board 12 wait until it reads unclamping done; on a pressure-board output switch the valve off and restore a pump this clamp started.

Parameters: